US Bellows is a Standards Subscriber | Exp: Dec 31, 2026 | See ejma.org to check verification process
Celebrating over 20 years of EJMA membership
The photograph above shows rectangular expansion joints being prepared for shipment to Russia. These were fabricated to replace units in a methanol plant duct system. The fabric belt is constructed of layers of material selected to handle the hot gases at low pressures. The frames can be fabricated from a variety of metals in a variety of shapes depending on the particular application.
U.S. Bellows, Inc. manufactures a stainless steel rectangular expansion joint, 28” x 66”, for an exhaust system at a chemical plant in South Carolina. This joint is equipped with a liner, tie rods system and mitered corner bellows design. The expansion joint was designed for 15 psig at 600°F and leak tested. A 100% dye-penetrant test was also performed on all the welds.
Read MoreU.S. Bellows “On-call” Engineering and Manufacturing Team Guarantee a response to your request within 30 minutes.
© 2025 U.S. Bellows, Inc. | All Rights Reserved | Privacy Policy | Facilities